6/29/2023 0 Comments Hemera steps per mm![]() To: default_envs - STM32F103RET6_crealityġ8. Before making changes to the firmware you will need to make sure PlatformIO is using the correct settings, change: default_envs - mega2560 You won't be able to select it, but as long as it's in the folder structure select: Open "Marlin-2.0.x"ġ7. Navigate to the location of the two folders you unzipped open: Marlin-2.0.x Back in Visual studio code click the platform io icon on the left toolbar, select: openġ6. Paste the files, when prompted select replace files in this destination.ġ5. Navigate back to the Home folder (where you moved the extracted folder to initially)ġ4. Copy all the files (ignoring DWIN_SET file as this is for the screen firmware)ġ3. You should now have the Ender-3 V2 specific configuration options visible in the finder window.ġ2. Open the folder: Configurations-release-xġ1. At this stage there should be two new files in your downloads folder: Configurations-release-xĮxtract these into a new folder for safekeeping.ġ0. This will take you to the GitHub page, Select: Code - Download zipĩ. This should take you to their GitHub page containing printer-specific configuration options.Ĩ. Before closing the window under configurations click View/ Download. The process should be the same., the file name, however, being slightly different.ħ. You may consider using the nightly bugfix for the most up to date version of marlin, there is also a bugfix variant of the configurations files. This guide demonstrates the latest (stable) build. Once the extension is installed you will notice the install icon changes to a cog.Ħ. ![]() Type PlatformIO into the search bar, then select install. Select the extension's icon, this should open up a list of potential extensions.Ĥ. If they are not you will need to toggle the visibility by selecting: view - appearance - show status barģ. Check to see if the icons on the left-hand side are visible. In order to use Visual studio code you will also need to install PlatformIO.Ģ. Download and install Visual studio code: Instead of the Arduino IDE we recommend the use of Visual studio code - Don't worry it's still free!ġ. The Creality Ender-3 V2 uses a 32-bit board this means there are some changes to the typical workflow that you were used to using with 8-bit boards. However, the guide has currently only been tested on a Creality Ender- 3 V2. At the time of writing the Creality Ender-3 V2 comes with the Creality 4.2.2 board (TMC) In theory if you are upgrading an existing Creality Ender 3 with the 4.2.7 board the same process will apply other than a board version definition later on in the guide.
0 Comments
Leave a Reply. |